Closest projects to AmigaDualFloppyInterface in the index. If they solve the same problem,
the maintainers may gain more from collaborating than from building in parallel.
-
Connect two floppy drives inside an Amiga computer and choose which one to boot from
-
Open Hardware Floppy Drive Swapper for Amiga Computers
-
Inexpensive A500 hard disk interface
-
Amiga DF0: / DF1: (_SEL0/_SEL1) internal automatic drive switch using Arduino Pro Mini and minimal hardware.
-
Adapter that allows external connection of floppy disk or Gotek drives
-
An Amiga 1000-500-2000-3000 DF0: - External Floppy Drive Swapper
-
A simple interface for standard PC Floppy Disk Drive and Amiga Computers
-
Amiga 2000 Coprocessor Board to support 2 selectable CPUs, 2 selectable kickstart ROMs (+ 2x A/B configuration options) at boot or reset.
-
FlashFloppy and FF_OSD, and now Amiga-dual-floppy-selector on a single board, for the Amiga 600
-
Amiga 600 and 1200 Microprocessor controlled drive switcher
-
Yet Another (Amiga) FDD Swapper
-
Adapts a regular PC floppy drive for high density operation on an Amiga computer
-
-
-
An internal Gotek mounting bracket for Amiga 500 designed in DesignSpark V4
-
Converts PC floppy drive interface to Amiga/Shugart bus interface. Now also supports the Atari ST/TT.
-
Allow standard PC floppy drives to be used with an Amiga
-
Backplate board to enable standard PC floppy to operate as an Amiga Floppy Drive
-
External floppy drive interface for Amiga
-
Interface allowing connection of unmodified floppy drives to Amiga, externally.
-
A small PCB done with KiCAD for my Amiga A1012 double floppy project
-
A side case for the Commodore Amiga 500 inspired by its original case.
-
-
External board initally meant to provide an external board for Goteks in Amiga 500.
-